Cisco Sx350

Ethernet Configuration Commands
405 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
17
Syntax
show interfaces counters
[interface-id | detailed ]
Parameters
• interface-id—(Optional) Specifies an interface ID. The interface ID can be
one of the following types: Ethernet port or port-channel.
• detailed—(Optional) Displays information for non-present ports in addition
to present ports.
Default Configuration
Display counters for all interfaces. If detailed is not used, only present ports are
displayed.
Command Mode
Privileged EXEC mode
Example
The following example displays traffic seen by all the physical interfaces.
switchxxxxxx# show interfaces counters gi11
Port InUcastPkts InMcastPkts InBcastPkts InOctets
---------- ------------ ------------ ------------ ------------
gi11 0 0 0 0
Port OutUcastPkts OutMcastPkts OutBcastPkts OutOctets
---------- ------------ ------------ ------------ ------------
gi11 0 1 35 7051
FCS Errors: 0
Single Collision Frames: 0
Multiple Collision Frames: 0
SQE Test Errors: 0
Deferred Transmissions: 0
Late Collisions: 0
Excessive Collisions: 0