Cisco Sx350

File System Commands
435 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
18
• at hh : mm —Schedules a reload of the image to take place at the specified
time (using a 24-hour clock). If you specify the month and day, the reload is
scheduled to take place at the specified time and date. If you do not specify
the month and day, the reload takes place at the specified time on the
current day (if the specified time is later than the current time) or on the next
day (if the specified time is earlier than the current time). Specifying 00:00
schedules the reload for midnight. The reload must take place within 24
hours.
• day —Number of the day in the range from 1 to 31.
• month —Month of the year. (Range: Jan–Dec)
• cancel—Cancels a scheduled reload.
Command Mode
Privileged EXEC mode
User Guidelines
Use the reload command to reload the switch.
Use the reload {in
hhh : mm | mmm | at hh : mm [ day month ]} command the command
to specify scheduled switch reload.
The at keyword can be configured only if the system clock has been set on the
switch.
When you specify the reload time using the at keyword, if you specify the month
and day, the reload takes place at the specified time and date. If you do not
specify the month and day, the reload takes place at the specified time on the
current day (if the specified time is later than the current time), or on the next day (if
the specified time is earlier than the current time). Specifying 00:00 schedules the
reload for midnight. The reload must take place within 24 days.
Use the reload cancel command to cancel the scheduled reload.
To display information about a scheduled reload, use the show reload command.
Example
Example 1. The following example reloads the switch:
switchxxxxxx# reload