Cisco Sx350

IPv6 Commands
593 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
28
• ICMP error messages—Specifies the minimum interval (in milliseconds)
between error messages sent on this interface.
• ICMP redirects—The state of Internet Control Message Protocol (ICMP)
IPv6 redirect messages on the interface (the sending of the messages is
enabled or disabled).
• number of DAD attempts:—Number of consecutive neighbor solicitation
messages that are sent on the interface while duplicate address detection
is performed.
• ND reachable time—Displays the neighbor discovery reachable time (in
milliseconds) assigned to this interface.
• ND advertised reachable time—Displays the neighbor discovery reachable
time (in milliseconds) advertised on this interface.
• ND advertised retransmit interval—Displays the neighbor discovery
retransmit interval (in milliseconds) advertised on this interface.
• ND router advertisements—Specifies the interval (in seconds) for neighbor
discovery router advertisements sent on this interface and the amount of
time before the advertisements expire.
• ND advertised default router preference is Medium—The DRP for the router
on a specific interface.
• MLD Version—The version of MLD
• Tunnel mode—Specifies the tunnel mode: isatap
• Tunnel Local IPv4 address—Specifies the tunnel local IPv4 address and
have one of the following formats:
- ipv4-address
- ipv4-address (auto)
- ipv4-address ( interface-id )
• Tunnel Remote Ipv4 address—Specifies the tunnel remote IPv4 address
• ISATAP Router DNS name is—The DNS name of the ISATAP Router
Example 3. The following command with the brief keyword displays information
about all interfaces that IPv6 is defined on: