Cisco Sx350

iSCSI QoS Commands
739 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
32
Syntax
iscsi qos {[vpt vpt ] [dscp dscp ] [queue queue ]}
no iscsi qos
Parameters
•
vpt vpt —Specifies a value of the VLAN Priority Tag (VPT) that iSCSI tagged
frames are assigned (Range: 0–7).
• dscp dscp —Specifies the Differentiated Services Code Point (DSCP) that
iSCSI frames are assigned. (Range: 0–63).
• queue queue —Specify the outgoing queue that iSCSI frames are sent
(Range: 1–8).
Default Configuration
•
VPT is not changed.
• DSCP is not changed.
• Queue—7
Command Mode
Global Configuration mode
User Guidelines
Use the iscsi qos command, to change the default quality of service profile
applying to iSCSI flows.
Note. At least one parameter is mandatory
Example
The following example configures the default quality of service profile applying to
iSCSI flows:
switchxxxxxx(config)# iscsi qos vpt 6 queue 8