Cisco Sx350

Link Layer Discovery Protocol (LLDP) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 770
36
To remove LLDP MED network policy, use the no form of this command.
Syntax
lldp med network-policy
number application [vlan vlan-id] [vlan-type {tagged |
untagged}] [up priority] [dscp value]
no lldp med network-policy number
Parameters
• number—Network policy sequential number. The range is 1-32.
• application—The name or the number of the primary function of the
application defined for this network policy. Available application names are:
- voice
- voice-signaling
- guest-voice
- guest-voice-signaling
- softphone-voice
- video-conferencing
- streaming-video
- video-signaling.
• vlan vlan-id —(Optional) VLAN identifier for the application.
• vlan-type—(Optional) Specifies if the application is using a tagged or an
untagged VLAN.
• up priority —(Optional) User Priority (Layer 2 priority) to be used for the
specified application.
• dscp value —(Optional) DSCP value to be used for the specified application.
Default Configuration
No network policy is defined.
Command Mode
Global Configuration mode