Cisco Sx350

Link Layer Discovery Protocol (LLDP) Commands
785 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
36
Example
The following examples display LLDP information that is advertised from
gi1 1 and
2.
switchxxxxxx# show lldp local gi11
Device ID: 0060.704C.73FF
Port ID: gi11
Capabilities: Bridge
System Name: ts-7800-1
System description:
Port description:
Management address: 172.16.1.8
802.3 MAC/PHY Configuration/Status
Auto-negotiation support: Supported
Auto-negotiation status: Enabled
Auto-negotiation Advertised Capabilities: 100BASE-TX full duplex, 1000BASE-T full
duplex
Operational MAU type: 1000BaseTFD
802.3 Link Aggregation
Aggregation capability: Capable of being aggregated
Aggregation status: Not currently in aggregation
Aggregation port ID: 1
802.3 Maximum Frame Size: 1522
Power Type: Type 1 PSE
Power Source: Primary Power Source
Power Priority: Unknown
PD Requested Power Value: 30
4-Pair POE supported: Yes
Spare Pair Detection/Classification required: Yes
PD Spare Pair Desired State: Enabled
802.3 EEE