Cisco Sx350

Network Management Protocol (SNMP) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 868
43
encrypted snmp-server user username groupname {v1 | v2c | [ remote host] v3[ auth
{md5 | sha} encrypted-auth-password [priv encrypted-priv-password]]}
no snmp-server user username {v1 | v2c | [remote host] v3[ auth {md5 | sha}
Parameters
• username—Define the name of the user on the host that connects to the
agent. (Range: Up to 20 characters).
• groupname—The name of the group to which the user belongs. The group
should be configured using the command snmp-server group with v1 or v2c
parameters (no specific order of the 2 command configurations is imposed
on the user). (Range: Up to 30 characters)
• v1—Specifies that the user is a v1 user.
• v2c—Specifies that the user is a v2c user..
• v3—Specifies that the user is a v3 user..
• remote host —(Optional) IP address (IPv4, IPv6 or IPv6z) or host name of the
remote SNMP host. See IPv6z Address Conventions.
• auth—(Optional) Specifies which authentication level is to be used.
• md5—(Optional) Specifies the HMAC-MD5-96 authentication level.
• Sha—(Optional) Specifies the HMAC-SHA-96 authentication level.
• auth-password—(Optional) Specifies the authentication password. Range:
Up to 32 characters.
• encrypted-auth-password—(Optional) Specifies the authentication
password in encrypted format.
• priv-password—(Optional) Specifies the privacy password (The
encryption algorithm used is data encryption standard - DES). Range: Up to
64 characters.
• encrypted-priv-password—(Optional) Specifies the privacy password in
encrypted format.
Default Configuration
No group entry exists.