Cisco Sx350

Network Management Protocol (SNMP) Commands
875 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
43
• udp-port port —(Optional) UDP port of the host to use. The default is 162.
(Range: 1–65535)
• filter filtername —(Optional) Filter for this host. If unspecified, nothing is
filtered. The filter is defined using snmp-server filter (no specific order of
commands is imposed on the user). (Range: Up to 30 characters)
• timeout seconds —(Optional) (For informs only) Number of seconds to wait
for an acknowledgment before resending informs. The default is 15
seconds. (Range: 1–300)
• retries retries —(Optional) (For informs only) Maximum number of times to
resend an inform request, when a response is not received for a generated
message. The default is 3. (Range: 0–255)
Default Configuration
Version: SNMP V1
Type of notification: Traps
udp-port: 162
If informs are specified, the default for retries: 3
Timeout: 15
Command Mode
Global Configuration mode
User Guidelines
The logical key of the command is the list (ip-address/hostname, traps/informs,
version).
When configuring SNMP v1 or v2 notifications recipient, the software
automatically generates a notification view for that recipient for all MIBs.
For SNMPv3 the software does not automatically create a user or a notify view.
, use the commands snmp-server user (ISCLI) and snmp-server group to create a
user or a group.
Example
The following defines a host at the IP address displayed.