Cisco Sx350

Quality of Service (QoS) Commands
947 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
47
User Guidelines
If no parameter is specified with the show qos interface command, the port QoS
mode (DSCP trusted, CoS trusted, untrusted, and so on), default CoS value,
DSCP-to-DSCP- map (if any) attached to the port, and policy map (if any) attached
to the interface are displayed. If a specific interface is not specified, the
information for all interfaces is displayed.
In case of Policers, Shapers and Rate Limit - only the ports which are not in the
default configuration will be showed.
Examples
Example 1—The following is an example of the output from the show qos interface
command.
switchxxxxxx(config)# show qos interface gi11
Ethernet gi10/1
Default CoS: 0
Trust mode: disabled
Ingress Policy applied: AV1
Egress Policy applied: AV2
Default ACE ingress action: deny-all
Default ACE egress action: deny-all
Example 2—The following is an example of the output from the show qos interface
queueing command for 4 queues.
switchxxxxxx(config)# show qos interface queueing gi11
Ethernet gi10/1
wrr bandwidth weights and EF priority:
qid-weights Ef - Priority
1 - N/A ena- 1
2 - N/A ena- 2
3 - N/A ena- 3
4 - N/A ena- 4