Command Groups 105
sFlow
SNMP
Command Description Mode*
sflow destination Configures sFlow collector parameters (owner string,
receiver timeout, ip address, and port).
GC
sflow polling Enables a new sflow poller instance for the data source if
rcvr_idx is valid.
GC
sflow polling (Interface Mode) Enable a new sflow poller instance for this data source if
rcvr_idx is valid.
IC
sflow sampling Enables a new sflow sampler instance for this data source if
rcvr_idx is valid.
GC
sflow sampling (Interface Mode) Enables a new sflow sampler instance for this data source if
rcvr_idx is valid.
IC
show sflow agent Displays the sflow agent information. PE
show sflow destination Displays all the configuration information related to the
sFlow receivers.
PE
show sflow polling Displays the sFlow polling instances created on the switch. PE
show sflow sampling Displays the sFlow sampling instances created on the
switch.
PE
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 51.
Command Description Mode*
show snmp Displays the SNMP status. PE
show snmp engineID Displays the SNMP engine ID. PE
show snmp filters Displays the configuration of filters. PE
show snmp groups Displays the configuration of groups. PE
show snmp users Displays the configuration of users. PE
show snmp views Displays the configuration of views. PE
show trapflags Shows the status of the configurable SNMP traps. PE
snmp-server community Sets up the community access string to permit access to
SNMP protocol.
GC
snmp-server community-group Maps SNMP v1 and v2 security models to the group name. GC
snmp-server contact Set
s up a system contact (sysContact) string.
GC
snmp-server enable traps Enables SNMP traps globally or enables specific SNMP
traps.
GC
To Next Page
Loading...
