Dell PowerConnect 8024 - Page 106

106 Command Groups
SSH
snmp-server engineID local Specifies the Simple Network Management Protocol
(SNMP) engine ID on the local switch.
GC
snmp-server filter Creates or updates an SNMP server filter entry. GC
snmp-server group Configures a new SNMP group or a table that maps SNMP
users to SNMP views.
GC
snmp-server host Specifies the recipient of SNMP notifications. GC
snmp-server location Sets
the system location string. GC
snmp-server enable traps
authentication
Enables the switch to send SNMP traps when
authentication failed.
GC
snmp-server v3-host Specifies the recipient of SNMPv3 notifications. GC
snmp-server user C onfigures a new SNMP Version 3 user. GC
snmp-server view Creates or updates a Simple Network Management Protocol
(SNMP) server view entry.
GC
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 51.
Command Description Mode*
crypto key generate dsa Generates DSA key pairs for the switch. GC
crypto key generate rsa Generates RSA key pairs for the switch. GC
crypto key pubkey-chain ssh Enters SSH Public Key-chain configuration mode. GC
ip ssh port Specifies the port to be used by the SSH server. GC
ip ssh pubkey-auth Enables public key authentication for incoming SSH
sessions.
GC
ip ssh server Enables the switch to be configured from a SSH server
connection.
GC
key-string Manually specifies a SSH public key. SK
show crypto key mypubkey Displays its own SSH public keys stored on the switch. PE
show crypto key pubkey-chain ssh Displays SSH public keys stored on the switch. PE
show ip ssh Displays the SSH server configuration. PE
user-key Specifies which SSH public key is manually configured and
enters the SSH public key-string configuration command.
SP
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 51.
Command Description Mode*