Command Groups 107
Syslog
System Management
Command Description Mode*
clear logging Clears messages from the internal logging buffer. PE
clear logging file Clears messages from the logging file. PE
description Describes the syslog server. L
level Specifies the importance level of syslog messages. L
loggin cli-command Enable CLI command logging GC
logging Logs messages to a syslog server GC
logging buffered Limits syslog messages displayed from an internal buffer
based on severity.
GC
logging console Limits messages logged to the console based on severity. GC
logging facility Sets the facility of the logging messages. GC
logging file Limits syslog messages sent to the logging file based on
severity.
GC
logging on Controls error messages logging. GC
port Specifies the port number of syslog messages. L
show logging Displays the state of logging and the syslog messages stored
in the internal buffer.
PE
show logging file Displays the state of logging and the syslog messages stored
in the logging file.
PE
show syslog-servers Displays the syslog servers settings. PE
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 51.
Command Description Mode*
asset-tag Specifies the switch asset-tag. GC
banner motd Enables and configures the message-of-the-day banners. GC
banner motd acknowledge Requires the user to acknowledge the banner displayed on
the console.
GC
clear power average Resets the average power consumption calculation. PE
cut-through mode Enables the cut-through mode on the switch. GC
hostname Specifies or modifies the switch host name. GC
low-power Enables the automatic transition of a device to a lower
power mode while the cable is not connected.
IC
To Next Page
Loading...
