Command Groups 109
Telnet Server
User Interface
switch priority Configures the ability of the switch to become the
Management Switch.
GC
switch renumber Changes the identifier for a switch in the stack. GC
telnet Logs into a host that supports Telnet. PE
traceroute Discovers the IP routes that packets actually take when
travelling to their destinations.
PE
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 51.
Command Description Mode*
ip telnet server disable Enables/disables the Telnet service on the switch. GC
ip telnet port Configures the Telnet service port number on the switch. GC
show ip telnet Displays the status of the Telnet server and the Telnet
service port number.
PE
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 51.
Command Description Mode*
enable Enters the privileged EXEC mode. UE
end Gets the CLI user control back to the privileged execution
mode or user execution mode.
Any
exit(configuration) Exits any configuration mode to the previously highest
mode in the CLI mode hierarchy.
(All)
exit(EXEC) Closes an active terminal session by logging off the switch. UE
mode simple Selects the simple mode as the start up mode. GC
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 51.
Command Description Mode*
To Next Page
Loading...
