Command Groups 49
Layer 3 Commands
ARP (IPv4) Manages Address Resolution Protocol functions.
DHCP and BOOTP Relay
(IPv4)
Manages DHCP/BOOTP operations on the system.
DHCPv6 Configures IPv6 DHCP functions.
DVMRP (Mcast) Configures DVMRP operations.
IGMP (Mcast) Configures IGMP operations.
IGMP Proxy (Mcast) Manages IGMP Proxy on the system.
IP Helper Configures relay of UDP packets.
IP Routing (IPv4) Configures IP routing and addressing.
IPv6 Multicast Manages IPv6 Multicasting on the system.
IPv6 Routing Configures IPv6 routing and addressing.
Loopback Interface (IPv6) Manages Loopback configurations.
Multicast (Mcast) Manages Multicasting on the system.
OSPF (IPv4)_ Manages shortest path operations.
OSPFv3 (IPv6) Manages IPv6 shortest path operations.
PIM-DM (Mcast) Configures PIM-DM operations.
PIM-SM (Mcast) Configures PIM-SM operations.
Router Discovery Protocol
(IPv4)
Manages router discovery operations.
Routing Information Protocol
(IPv4)
Configures RIP activities.
Tunnel Interface (IPv6) Managing tunneling operations.
Virtual Router Redundancy
(IPv4)
Manages router redundancy on the system.
Utility Commands
Auto Config Automatically configures switch when a configuration file is not found.
Captive Portal Blocks clients from accessing network until user verification is
established.
Clock Configures the system clock.
Configuration and Image Files Manages the switch configuration files.
Denial of Service Provides several Denial of Service options.
Table 1-1. System Command Groups
(continued)
Command Group Description
To Next Page
Loading...
