Dell PowerConnect 8024 - Page 59

Command Groups 59
Ethernet Configuration
Command Description Mode*
clear counters Clears statistics on an interface. PE
description Adds a description to an interface. IC
duplex Configures the full/half duplex operation of a given
Ethernet interface when not using auto-negotiation.
IC
flowcontrol Configures the flow control on a given interface. GC
interface ethernet Enters the interface configuration mode to configure an
Ethernet type interface.
GC
interface range ethernet Enters the interface configuration mode to configure
multiple Ethernet type interfaces.
GC
mtu
Enables jumbo frames on an interface by adjusting the
maximum size of a packet or maximum transmission
unit (MTU).
IC
negotiation Enables auto-negotiation operation for the speed and
duplex parameters of a given interface.
IC
show interfaces advertise Displays information about auto negotiation advertisement. PE
show interfaces configuration Displays the configuration for all configured interfaces. UE
show interfaces counters Displays traffic seen by the physical interface. UE
show interfaces counters Displays traffic seen by the interface, including Received
Priority Flow Control Frames and Transmitted PFC Frames
for a given ethernet or port-channel interface.
PE
show interfaces description Displays the description for all configured interfaces. UE
show interfaces status Displays the status for all configured interfaces. UE
show statistics ethernet Displays statistics for one port or for the entire switch. PE
show storm-control Displays the storm control configuration. PE
shutdown Disables interfaces. IC
speed Configures the speed of a given Ethernet interface when
not using auto-negotiation.
IC
storm-control broadcast Enables Broadcast storm control. IC
storm-control multicast Enables the switch to count Multicast packets together with
Broadcast packets.
IC
storm-control unicast Enables Unicast storm control. IC
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 51.