Command Groups 71
primary Specifies that a configured server should be the primary
server in the group of authentication servers which have the
same server name.
R
priority Specifies the order in which the servers are to be used, with
0 being the highest priority.
R
radius-server deadtime Improves RADIUS response times when servers are
unavailable. Causes the unavailable servers to be skipped.
GC
radius-server host Specifies a RADIUS server host. GC
radius-server key Sets the authentication and encryption key for all RADIUS
communications between the switch and the RADIUS
daemon.
GC
radius-server retransmit Specifies the number of times the software searches the list
of RADIUS server hosts.
GC
radius-server source-ip Specifies the source IP address used for communication
with RADIUS servers.
GC
radius-server timeout Sets the interval for which a switch waits for a server host to
reply
GC
retransmit Specifies the number of times the software searches the list
of RADIUS server hosts before stopping the search.
R
show radius-servers Displays the RADIUS server settings. PE
show radius-servers statistics Shows the statistics for an authentication or accounting
server.
PE
source-ip Specifies the source IP address to be used for
communication with RADIUS servers.
R
timeout Sets the timeout value in seconds for the designated radius
server.
R
usage Specifies the usage type of the server. R
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 51.
Command Description Mode*
To Next Page
Loading...
