Dell PowerConnect 8024 - Page 761

OSPF Commands 761
RFC 1583
Compatibility
Reflects whether 1583 compatibility is enabled or disabled. This is a configured
value.
Opaque Capability Shows whether router is capable of sending Opaque LSA's. This is a configured
value.
ABR Status Shows whether the router is an OSPF Area Border Router.
Exit Overflow Interval Shows the number of seconds that, after entering OverflowState, a router will
attempt to leave OverflowState.
External LSA Count Shows the number of external (LS type 5) link-state advertisements in the link-
state database.
External LSA
Checksum
Shows the sum of the LS checksums of external link-state advertisements
contained in the link-state database.
AS_OPAQUE LSA
Count
Shows the number of AS Opaque LSA's received.
AS_OPAQUE LSA Checksum Shows the Checksum of received AS Opaque LSA's
New LSAs Originated Shows the number of new link-state advertisements that have been originated.
LSAs Received Shows the number of link-state advertisements received determined to be new
instantiations.
External LSDB Limit Shows the maximum number of non-default AS-external-LSAs entries that can
be stored in the link-state database.
Default Metric Default value for redistributed routes.
Default Route Advertise Indicates whether the default routes received from other source protocols are
advertised or not
Always Shows whether default routes are always advertised.
Metric Shows the metric for the advertised default routes. If the metric is not
configured, this field is blank.
Metric Type Shows whether the routes are External Type 1 or External Type 2.
Maximum Paths Shows the maximum number of paths that OSPF can report for a given
destination.
Redistributing This field is a heading and appears only if you configure the system to take
routes learned from a non-OSPF source and advertise them to its peers.
Source Shows source protocol/routes that are being redistributed. Possible values are
static, connected, BGP, or RIP.
Tag Shows the decimal value attached to each external route.
Subnets For redistributing routes into OSPF, the scope of redistribution for the specified
protocol.
Distribute-List Shows the access list used to filter redistributed routes.