Command Groups 95
Routing Information Protocol
Command Description Mode*
auto-summary Enables the RIP auto-summarization mode. RIP
default-information originate Controls the advertisement of default routes. RIP
default-metric Sets a default for the metric of distributed routes. RIP
distance rip Sets the route preference value of RIP in the router. RIP
distribute-list out Specifies the access list to filter routes received from the
source protocol.
RIP
enable Resets the default administrative mode of RIP in the router
(active).
RIP
hostroutesaccept Enables the RIP hostroutesaccept mode. RIP
ip rip Enables RIP on a router interface. IC
ip rip authentication Sets the RIP Version 2 Authentication Type and Key for the
specified interface.
IC
ip rip receive version Configures the interface to allow RIP control packets of the
specified version(s) to be received.
IC
ip rip send version Configures the interface to allow RIP control packets of the
specified version to be sent.
IC
redistribute Configures OSPF protocol to allow redistribution of routes
from the specified source protocol/routers.
PIP
router rip Enters Router RIP mode. GC
show ip rip Displays information relevant to the RIP router. PE
show ip rip interface Displays information related to a particular RIP interface. PE
show ip rip interface brief Displays general information for each RIP interface. PE
split-horizon Sets the RIP split horizon mode. RIP
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 51.
To Next Page
Loading...
