CDP Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 230
8
cdp globally is disabled
Example 2 - In this example, CDP is globally enabled but disabled on the port and
no information is displayed.
switchxxxxxx#
show cdp tlv
gi12
cdp globally is enabled
Capability Codes: R - Router,T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater,
P - VoIP Phone,M - Remotely-Managed Device,
C - CAST Phone Port, W - Two-Port MAC Relay
Interface TLV: gi12
CDP is disabled on gi12
Example 3 - In this example, CDP is globally enabled and enabled on the port, but
the port is down and no information is displayed.
switchxxxxxx#
show cdp tlv interface
gi12
cdp globally is enabled
Capability Codes: R - Router,T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater,
P - VoIP Phone,M - Remotely-Managed Device,
C - CAST Phone Port, W - Two-Port MAC Relay
Interface TLV: gi13
CDP is enabled on gi13
Ethernet gi13 is down
Example 4 - In this example, CDP is globally enabled, and no ports are specified,
so information is displayed for all ports on which CDP is enabled who are up.
switchxxxxxx#
show cdp tlv interface
cdp globally is enabled
Capability Codes: R - Router,T - Trans Bridge, B - Source Route Bridge
To Next Page
Loading...
