Cisco Sx350

CDP Commands
231 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
8
S - Switch, H - Host, I - IGMP, r - Repeater,
P - VoIP Phone,M - Remotely-Managed Device,
C - CAST Phone Port, W - Two-Port MAC Relay
Interface TLV: gi11
CDP is enabled
Ethernet gi11 is up,
Device ID TLV: type is MAC address; Value is 00:11:22:22:33:33:44:44
Address TLV: IPv4: 1.2.2.2 IPv6:
Port_ID TLV: gi11
Capabilities: S, I
Version TLV: 1 and 2
Platform TLV: VSD Ardd
Native VLAN TLV: 1
Full/Half Duplex TLV: full-duplex
Appliance VLAN_ID TLV: Appliance-ID is 1; VLAN-ID is 100
COS for Untrusted Ports TLV: 1
sysName: a-switch
4-wire Power-via-MDI (UPOE) TLV:
4-pair PoE Supported: No
Power Available TLV: Request-ID is 1 Power management-ID is 1;
Available-Power is 15.4;
Management-Power-Level is 0xFFFFFFFF
Interface TLV: gi12
CDP is disabled on gi12
Interface TLV: gi13
CDP is enabled on gi13
Ethernet gi13 is down
Example 5 - In this example, CDP is globally enabled and enabled on the PSE PoE
port, which is up and information is displayed.