Cisco Sx350

Introduction
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 30
1
• exit
• end
• Ctrl+Z
The following example shows how to access Global Configuration mode and
return to Privileged EXEC mode:
Interface or Line Configuration Modes
Various submodes may be entered from Global Configuration mode. These
submodes enable performing commands on a group of interfaces or lines.
For instance to perform several operations on a specific port or range of ports, you
can enter the Interface Configuration mode for that interface.
The following example enters Interface Configuration mode for vlan1 and then sets
their speed:
The exit command returns to Global Configuration mode.
The following is a sample of some of the available submodes:
• Interface—Contains commands that configure a specific interface (port,
VLAN, port channel, or tunnel) or range of interfaces. The Global
Configuration mode command interface is used to enter the Interface
switchxxxxxx#
switchxxxxxx# configure
switchxxxxxx(config)# exit
switchxxxxxx#
switchxxxxxx#
switchxxxxxx# configure
switchxxxxxx(config)# interface range vlan1
switchxxxxxx(config-if)#speed 10
switchxxxxxx(config-if)#exit
switchxxxxxx(config)#