Cisco Sx350

EEE Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 376
16
User Guidelines
If the port is a 10G port, but the link speed is 1G, the EEE Remote status cannot be
resolved (and displayed).
Examples
Example 1 - The following displays brief Information about all ports.
switchxxxxxx# show eee
EEE globally enabled
EEE Administrate status is enabled on ports: gi11-2, gi14
EEE Operational status is enabled on ports: gi11-2, gi14
EEE LLDP Administrate status is enabled on ports: gi11-3
EEE LLDP Operational status is enabled on ports: gi11-2
Example 2 - The following is the information displayed when a port is in the Not
Present state; no information is displayed if the port supports EEE.
switchxxxxxx# show eee gi11
Port Status: notPresent
EEE Administrate status: enabled
EEE LLDP Administrate status: enabled
Example 3 - The following is the information displayed when the port is in status
DOWN.
switchxxxxxx# show eee gi11
Port Status: DOWN
EEE capabilities:
Speed 10M: EEE not supported
Speed 100M: EEE supported
Speed
1G : EEE supported