IP System Management Commands
543 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
26
7 so-0-2-0x1.aa1.mich.net (192.122.183.9) 56 msec 53 msec 54 msec
8 atm1-0x24.michnet8.mich.net (198.108.23.82) 56 msec 56 msec 57 msec
9 * * *
10 A-ARB3-LSA-NG.c-SEB.umnet.umich.edu(141.211.5.22)58 msec 58msec 58 msec
11 umaxp1.physics.lsa.umich.edu (141.211.101.64) 62 msec 63 msec 63 msec
Trace completed
The following table describes the significant fields shown in the display:
The following are characters that can appear in the traceroute command output:
Field Description
1 Indicates the sequence number of the router
in the path to the host.
i2-gateway.stanford.
edu
Host name of this router.
192.68.191.83 IP address of this router.
1 msec 1 msec 1
msec
Round-trip time for each of the probes that
are sent.
Field Description
* The probe timed out.
? Unknown packet type.
A Administratively unreachable. Usually, this output
indicates that an access list is blocking traffic.
F Fragmentation required and DF is set.
H Host unreachable.
N Network unreachable.
P Protocol unreachable.
Q Source quench.
R Fragment reassembly time exceeded
S Source route failed.
U Port unreachable.
To Next Page
Loading...
