Cisco Sx350

Link Layer Discovery Protocol (LLDP) Commands
793 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
36
The following table describes significant LLDP fields shown in the display:
Field Description
Port The port number.
Device ID The neighbor device’s configured ID (name)
or MAC address.
Port ID The neighbor device’s port ID.
System name The neighbor device’s administratively
assigned name.
Capabilities The capabilities discovered on the neighbor
device. Possible values are:
B - Bridge
R - Router
W - WLAN Access Point
T - Telephone
D - DOCSIS cable device
H - Host
r - Repeater
O - Other
System description The neighbor device’s system description.
Port description The neighbor device’s port description.
Management
address
The neighbor device’s management address.
Auto-negotiation
support
The auto-negotiation support status on the
port. (supported or not supported)
Auto-negotiation
status
The active status of auto-negotiation on the
port. (enabled or disabled)
Auto-negotiation
Advertised
Capabilities
The port speed/duplex/flow-control
capabilities advertised by the
auto-negotiation.
Operational MAU
type
The port MAU type.