Cisco Sx350

Power over Ethernet (PoE) Commands
901 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
45
Inrush test: Enabled
Example 2—The following example displays information about the inline power for
a specific port.
switchxxxxxx(config)# show power inline gi1 1
Port status: Port is on - Valid PD resistor signature detected
Port standard: 802.3AT
Admin power limit: 30.0 watts
Unit Module Nominal
power (w)
Consumed
Power (w)
Temp (c)
-----
-
----------------------------------------------
-----
-------------
-
--------------
--
------------
-
1 48P 320 120 (37.5%) 30
2 24P 240 0 (0%) 50
3 24P 120 0 (0%) 50
Interface Admin Oper Power Class Device Priority
-------- ---------
-
-----------
--
--------
-
------- ------------------- ----------
-
gi1 1 Auto On 15.4(3
0)
3 IP Phone Model A Critical
gi1 2 Auto Searchin
g
00 High
gi1 3 Never Off 0 0 Low
Interface Admin Oper Power Class Device Priority
-------- ---------
-
-----------
--
--------
-
------- ------------------- ----------
-
gi1 1 Auto On 3 IP Phone Model A Critical