Cisco Sx350

Power over Ethernet (PoE) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 902
45
Time range:
Link partner standard: 802.3AF
Operational power limit: 30 watts
Negiotiated power: 0 watts (None)
Spare pair: Enabled (forced)
Current (mA):
81
Voltage(V): 50.8
verload Counter: 5
Short Counter: 0
Denied Counter: 2
Absent Counter: 0
Invalid Signature Counter: 0
The following table describes the fields shown in the display:
Field Description
Power Inline power sourcing equipment operational
status.
Nominal Power Inline power sourcing equipment nominal
power in Watts.
Consumed
Power
Measured usage power in Watts.
Usage Threshold Usage threshold expressed in percent for
comparing the measured power and initiating
an alarm if threshold is exceeded.
Traps Indicates if inline power traps are enabled.
Port Ethernet port number.
device Description of the device type.
State Indicates if the port is enabled to provide
power. The possible values are Auto or Never.
Priority Port inline power management priority. The
possible values are Critical, High or Low.
Status Power operational state. The possible values
are On, Off, Test-Fail, Testing, Searching or Fault.
Class Power consumption classification of the
device.