Cisco Sx350

Power over Ethernet (PoE) Commands
903 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
45
Overload
Counter
Counts the number of overload conditions
detected.
Short Counter Counts the number of short conditions
detected.
Denied Counter Counts the number of times power was denied.
Absent Counter Counts the number of times power was
removed because device dropout was
detected.
Invalid Signature
Counter
Counts the number of times an invalid signature
of a device was detected.
Inrush Test Displays whether the inrush test is enabled or
disabled.
Field Description
Port limit mode Enabled for port limit and Disable for class limit.
Legacy Mode Enabled of Disabled legacy device support.
Inrush Test Displays whether the inrush test is enabled or
disabled.
SW version The POE firmware version.
Usage Threshold Usage threshold expressed in percent for
comparing the measured power and initiating
an alarm if threshold is exceeded.
Traps Indicates if inline power traps are enabled.
Module The module name.
Available Power Inline power sourcing equipment nominal
power in Watts.
Consumed
Power
Measured usage power in Watts.
Temp Show the POE device temperature.
Interface Ethernet port number.
Admin Indicates if the port is enabled to provide
power. The possible values are Auto or Never.
Oper Power operational state. The possible values
are On, Off, Test-Fail, Testing, Searching or Fault.
Power Power consumed in watts.
Field Description