Dell PowerConnect 8024 - Page 89

Command Groups 89
ip ospf authentication Sets the OSPF Authentication Type and Key for the
specified interface.
IC
ip ospf cost Configures the cost on an OSPF interface. IC
ip ospf dead-interval Sets the OSPF dead interval for the specified interface. IC
ip ospf hello-interval Sets the OSPF hello interval for the specified interface. IC
ip ospf mtu-ignore Disables OSPF maximum transmission unit (MTU)
mismatch detection.
IC
ip ospf network Configure OSPF to treat an interface as a point-to-point
rather than broadcast interface.
IC
ip ospf priority Sets the OSPF priority for the specified router interface. IC
ip ospf retransmit-interval Sets the OSPF retransmit Interval for the specified
interface.
IC
ip ospf transmit-delay Sets the OSPF Transit Delay for the specified interface. IC
maximum-paths Sets the number of paths that OSPF can report for a given
destination.
ROSPF
network area Enables OSPFv2 on an interface and sets its area ID if the
IP address of an interface is covered by this network
command.
ROSPF
passive-interface Sets the interface or tunnel as passive. IC
passive-interface default Enables the global passive mode by default for all
interfaces.
ROSPF
passive-interface (router mode) Sets the interface or tunnel as passive. ROSPF
redistribute Configures OSPF protocol to allow redistribution of routes
from the specified source protocol/routers.
ROSPF
router-id Sets a 4-digit dotted-decimal number uniquely identifying
the router OSPF ID.
ROSPF
router ospf Enters Router OSPF mode. GC
show ip ospf Displays information relevant to the OSPF router. PE
show ip ospf abr Displays the internal OSPF routing table entries to Area
Border Routers (ABR).
PE
show ip ospf area Displays information about the identified OSPF area. PE
show ip ospf asbr Displays the internal OSPF routing table entries to
Autonomous System Boundary Routes (ASBR).
PE
show ip ospf database Displays information about the link state database when
OSPF is enabled.
PE
Command Description Mode*