Dell PowerConnect 8024 - Page 92

92 Command Groups
ipv6 ospf retransmit-interval Sets the OSPF retransmit interval for the specified
interface.
IC
ipv6 ospf transmit-delay Sets the OSPF Transmit Delay for the specified interface. IC
ipv6 router ospf Enters Router OSPFv3 Configuration mode. GC
maximum-paths Sets the number of paths that OSPF can report for a given
destination.
ROSV3
passive-interface Sets the interface or tunnel as passive. IC
passive-interface default Enables the global passive mode by default for all interfaces. ROSV3
redistribute Configures the OSPFv3 protocol to allow redistribution of
routes from the specified source protocol/routers.
ROSV3
router-id Sets a 4-digit dotted-decimal number uniquely identifying
the Router OSPF ID.
ROSV3
show ipv6 ospf Displays information relevant to the OSPF router. PE
show ipv6 ospf abr Displays the internal OSPFv3 routes to reach Area Border
Routers (ABR).
PE
show ipv6 ospf area Displays information about the area. PE
show ipv6 ospf asbr Displays the internal OSPFv3 routes to reach Autonomous
System Boundary Routes (ASBR).
PE
show ipv6 ospf database Displays information about the link state database when
OSPFv3 is enabled.
PE
show ipv6 ospf database database-
summary
Displays the number of each type of LSA in the database
and the total number of LSAs in the database.
PE
show ipv6 ospf interface Displays the information for the IFO object or virtual
interface tables.
PE
show ipv6 ospf interface brief Displays brief information for the IFO object or virtual
interface tables.
PE
show ipv6 ospf interface stats Displays the statistics for a specific interface. UE
show ipv6 ospf interface vlan Displays OSPFv3 configuration and status information for a
specific vlan
PE
show ipv6 ospf neighbor Displays information about OSPF neighbors. PE
show ipv6 ospf range Displays information about the area ranges for the specified
area identifier.
PE
show ipv6 ospf stub table Displays the OSPF stub table. PE
show ipv6 ospf virtual-link Displays the OSPF Virtual Interface information for a
specific area and neighbor.
PE
Command Description Mode*