Cisco Sx350

IPv6 Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 604
28
Default Configuration
All IPv6 static routing information for all active routing tables is displayed.
Command Mode
User EXEC mode
Privileged EXEC mode
User Guidelines
When the
ipv6-address or ipv6-prefix / prefix-length argument is specified, a
longest match lookup is performed from the routing table and only route
information for that address or network is displayed. Only the information matching
the criteria specified in the command syntax is displayed. For example, when the
interface-id argument is specified, only the specified interface-specific routes are
displayed.
When the detail keyword is specified, the reason why the route is not valid is
displayed for invalid direct or fully specified routes.
Examples
Example 1. The following is sample output from the show ipv6 static command
without specified options:
switchxxxxxx# show ipv6 static
IPv6 Static routes Code: * - installed in Routing Information Base (RIB)
IPv6 Static routes distance is 1
* 3000::/16, interface VLAN1, metric 1
* 4000::/16, via nexthop 2001:1::1, metric 1
5000::/16, interface VLAN2, metric 1
* 5555::/16, via nexthop 4000::1, metric 1
5555::/16, via nexthop 9999::1, metric 1
* 5555::/16, via nexthop 4001:AF00::1, metric 1
* 6000::/16, via nexthop 2007::1, metric 1