Cisco Sx350

Link Layer Discovery Protocol (LLDP) Commands
797 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
36
Management
address
The neighbor device’s management address.
Auto-negotiation
support
The auto-negotiation support status on the port.
(Supported or Not Supported)
Auto-negotiation
status
The active status of auto-negotiation on the port.
(Enabled or Disabled)
Auto-negotiation
Advertised
Capabilities
The port speed/duplex/flow-control capabilities
advertised by the auto-negotiation.
Operational MAU
type
The port MAU type.
LLDP MED
Capabilities The sender's LLDP-MED capabilities.
Device type The device type. Indicates whether the sender is a
Network Connectivity Device or Endpoint Device,
and if an Endpoint, to which Endpoint Class it
belongs.
LLDP MED - Network Policy
Application type The primary function of the application defined for
this network policy.
Flags Flags. The possible values are:
Unknown policy: Policy is required by the device,
but is currently unknown.
Tagged VLAN: The specified application type is
using a Tagged VLAN.
Untagged VLAN: The specified application type is
using an Untagged VLAN.
VLAN ID The VLAN identifier for the application.
Layer 2 priority The Layer 2 priority used for the specified
application.
DSCP The DSCP value used for the specified application.
LLDP MED - Power Over Ethernet
Power type The device power type. The possible values are:
Power Sourcing Entity (PSE) or Power Device (PD).
Field Description