Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-100
v1.0, July 2010
lacp partner admin state passive
Use this command to set the LACP partner admin state to passive.
no lacp partner admin state passive
Use this command to set the LACP partner admin state to active.
lacp partner port id
Use this command to configure the LACP partner port id. The valid range for <port-id> is 0 to
65535.
Format lacp partner admin state passive
Mode Interface Config
Note: This command is only applicable to physical interfaces.
Format no lacp partner admin state passive
Mode Interface Config
Default 0x80
Format lacp partner portid <port-id>
Mode Interface Config
Note: This command is only applicable to physical interfaces.
To Next Page
Loading...
