Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-50
v1.0, July 2010
external-lsdb-limit (OSPFv3)
This command configures the external LSDB limit for OSPF. If the value is –1, then there is no
limit. When the number of non-default AS-external-LSAs in a router’s link-state database reaches
the external LSDB limit, the router enters overflow state. The router never holds more than the
external LSDB limit non-default AS-external-LSAs in it database. The external LSDB limit
MUST be set identically in all routers attached to the OSPF backbone and/or any regular OSPF
area. The range for <limit> is –1 to 2147483647.
no external-lsdb-limit
This command configures the default external LSDB limit for OSPF.
maximum-paths (OSPFv3)
This command sets the number of paths that OSPF can report for a given destination where
maxpaths is platform dependent.
no maximum-paths
This command resets the number of paths that OSPF can report for a given destination back to its
default value.
Default -1
Format external-lsdb-limit
<limit>
Mode Router OSPFv3 Config
Format no external-lsdb-limit
Mode Router OSPFv3 Config
Default 4
Format maximum-paths <maxpaths>
Mode Router OSPFv3 Config
Format no maximum-paths
Mode Router OSPFv3 Config
To Next Page
Loading...
Need help?
General
