NETGEAR GSM7228PS - GARP Commands; Show Private-Group

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-56
v1.0, July 2010
no private-group name
This command is used to remove the specified private group.
show private-group
This command displays the private groups’ information.
GARP Commands
This section describes the commands you use to configure Generic Attribute Registration Protocol
(GARP) and view GARP status. The commands in this section affect both GARP VLAN
Registration Protocol (GVRP) and Garp Multicast Registration Protocol (GMRP). GARP is a
protocol that allows client stations to register with the switch for membership in VLANS (by using
GVMP) or multicast groups (by using GVMP).
Format private-group name <privategroup-name>
Mode Global Config
Format show private-groupname [<private-group-name>|<private-group-
id>|port <unit/slot/port>]
Mode Priviledged EXEC
Term Definition
Interface Valid slot and port number separated by forward slashes.
Port VLANID
The VLAN ID associated with the port.
Private Group
ID
Total number of private groups is 192.
Private Group
Name
The name string can be up to 24 bytes of non-blank characters
Private Group The mode can be either “isolated” or “community”.