Managed Switch CLI Manual, Release 8.0.3
Quality of Service (QoS) Commands 8-6
v1.0, July 2010
show classofservice ip-precedence-mapping
This command displays the current IP Precedence mapping to internal traffic classes for a specific
interface. The unit/slot/port parameter is optional and is only valid on platforms that support
independent per-port class of service mappings. If specified, the IP Precedence mapping table of
the interface is displayed. If omitted, the most recent global configuration settings are displayed.
The following information is repeated for each user priority.
show classofservice ip-dscp-mapping
This command displays the current IP DSCP mapping to internal traffic classes for the global
configuration settings.
The following information is repeated for each user priority.
Format show classofservice ip-precedence-mapping [<unit/slot/port>]
Mode Privileged EXEC
Term Definition
IP Precedence The IP Precedence value.
Traffic Class The traffic class internal queue identifier to which the IP Precedence value is mapped.
Format show classofservice ip-dscp-mapping
Mode Privileged EXEC
Term Definition
IP DSCP The IP DSCP value.
Traffic Class The traffic class internal queue identifier to which the IP DSCP value is mapped.
To Next Page
Loading...
Need help?
General
