Managed Switch CLI Manual, Release 8.0.3
IP Multicast Commands 5-26
v1.0, July 2010
show ip pimsm rp mapping
Use this command to display all group-to-RP mappings of which the router is a aware (either
configured or learned from the bootstrap router (BSR)). If no RP is specified, all active RPs are
displayed.
Internet Group Message Protocol (IGMP) Commands
This section describes the commands you use to view and configure IGMP settings.
ip igmp
This command sets the administrative mode of IGMP in the system to active.
no ip igmp
This command sets the administrative mode of IGMP in the system to inactive.
Format show ip pimsm rp mapping [rp address]
Modes • Privileged EXEC
• User EXEC
Default disabled
Format ip igmp
Modes • Global Config
• Interface Config
Format no ip igmp
Modes • Global Config
• Interface Config
To Next Page
Loading...
