Managed Switch CLI Manual, Release 8.0.3
IPv6 Multicast Commands 6-19
v1.0, July 2010
ipv6 mld last-member-query-count
Use this command to set the number of listener-specific queries sent before the router assumes that
there are no local members on the interface. The range for <last-member-query-count> is
1 to 20.
no ipv6 mld last-member-query-count
Use this command to reset the <last-member-query-count> parameter of the interface to
the default value.
show ipv6 mld groups
Use this command to display information about multicast groups that MLD reported. The
information is displayed only when MLD is enabled on at least one interface. If MLD was not
enabled on even one interface, there is no group information to be displayed.
The following fields are displayed as a table when <unit/slot/port> is specified.
Default 2
Format ipv6 mld last-member-query-count <last-member-query-count>
Mode Interface Config
Format no ipv6 mld last-member-query-count
Mode Interface Config
Format show ipv6 mld groups {<unit/slot/port> | <group-address>}
Mode • Privileged EXEC
• User EXEC
Field Description
Group Address The address of the multicast group.
Interface Interface through which the multicast group is reachable.
Up Time Time elapsed in hours, minutes, and seconds since the multicast group has been known.
Expiry Time Time left in hours, minutes, and seconds before the entry is removed from the MLD
membership table.
To Next Page
Loading...
