Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-67
v1.0, July 2010
Timeouts...................................... 0
Unknown Types................................. 0
Packets Dropped............................... 0
TACACS+ Commands
TACACS+ provides access control for networked devices via one or more centralized servers.
Similar to RADIUS, this protocol simplifies authentication by making use of a single database that
can be shared by many clients on a large network. TACACS+ is based on the TACACS protocol
(described in RFC1492) but additionally provides for separate authentication, authorization, and
accounting services. The original protocol was UDP based with messages passed in clear text over
the network; TACACS+ uses TCP to ensure reliable delivery and a shared key configured on the
client and daemon server to encrypt all messages.
tacacs-server host
Use the tacacs-server host command in Global Configuration mode to configure a
TACACS+ server. This command enters into the TACACS+ configuration mode. The <ip-
address|hostname> parameter is the IP address or hostname of the TACACS+ server. To
specify multiple hosts, multiple
tacacs-server host commands can be used.
no tacacs-server host
Use the no tacacs-server host command to delete the specified hostname or IP address.
The <ip-address|hostname> parameter is the IP address of the TACACS+ server.
Format tacacs-server host <ip-address|hostname>
Mode Global Config
Format no tacacs-server host
<ip-address|hostname>
Mode Global Config
To Next Page
Loading...
