NETGEAR GSM7228PS - Redirect (Captive Portal)

Managed Switch CLI Manual, Release 8.0.3
Captive Portal Commands 12-8
v1.0, July 2010
group
Use this command to configure a group ID for this captive portal configuration. If a group number
is configured, the user entry (Local or RADIUS) must be configured with the ame name and the
group to authenticate to this captive portal instance. The group ID must be xist first. You can use
the command “user group <1-10>” to create a group ID. The default group ID is 1 for a captive
portal configuration.
no group
Use this command to reset the group number to the default.
redirect (Captive Portal)
Use this command to enable the redirect mode for a captive portal configuration. Use the “no”
form of this command to disable redirect mode.
no redirect
Use this command to disable redirect mode.
Default 1
Format group <1-10>
Mode Captive Portal Instance mode
Default 1
Format no group <1-10>
Mode Captive Portal Instance mode
Default disable
Format redirect
Mode Captive Portal Instance mode