Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-18
v1.0, July 2010
no ipv6 nd ra-lifetime
This command resets router lifetime to the default value.
ipv6 nd reachable-time
This command sets the router advertisement time to consider a neighbor reachable after neighbor
discovery confirmation. Reachable time is specified in milliseconds. A value of zero means the
time is unspecified by the router.
no ipv6 nd reachable-time
This command means reachable time is unspecified for the router.
ipv6 nd suppress-ra
This command suppresses router advertisement transmission on an interface.
Default 1800
Format ipv6 nd ra-lifetime <lifetime>
Mode Interface Config
Format no ipv6 nd ra-lifetime
Mode Interface Config
Default 0
Format ipv6 nd reachable-time <0–3600000>
Mode Interface Config
Format no ipv6 nd reachable-time
Mode Interface Config
Default disabled
To Next Page
Loading...
