Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-67
v1.0, July 2010
show ipv6 ospf stub table
This command displays the OSPF stub table. The information below will only be displayed if
OSPF is initialized on the switch.
show ipv6 ospf virtual-link
This command displays the OSPF Virtual Interface information for a specific area and neighbor.
The <areaid> parameter identifies the area and the <neighbor> parameter identifies the
neighbor’s Router ID.
Format show ipv6 ospf stub table
Modes • Privileged EXEC
• User EXEC
Term Definition
Area ID A 32-bit identifier for the created stub area.
Type of Service Type of service associated with the stub metric. For this release, Normal TOS is the only
supported type.
Metric Val The metric value is applied based on the TOS. It defaults to the least metric of the type of
service among the interfaces to other areas. The OSPF cost for a route is a function of
the metric value.
Import
Summary LSA
Controls the import of summary LSAs into stub areas.
Format show ipv6 ospf virtual-link <areaid> <neighbor>
Modes • Privileged EXEC
• User EXEC
Term Definition
Area ID The area id of the requested OSPF area.
Neighbor
Router ID
The input neighbor Router ID.
Hello Interval The configured hello interval for the OSPF virtual interface.
To Next Page
Loading...
Need help?
General
