NETGEAR GSM7228PS - Show Ipv6 Route Summary

Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-27
v1.0, July 2010
show ipv6 route summary
This command displays the summary of the routing table. Use all to display the count summary
for all routes, including best and non-best routes. Use the command without parameters to display
the count summary for only the best routes.
Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 route summary
IPv6 Routing Table Summary - 3 entries
Connected Routes..............................1
Static Routes.................................2
OSPF Routes...................................0
Intra Area Routes...........................0
Inter Area Routes...........................0
External Type-1 Routes......................0
External Type-2 Routes......................0
Reject Routes.................................1
Total routes..................................3
Number of Prefixes:
/64: 3
Format show ipv6 route summary [all]
Modes • Privileged EXEC
• User EXEC
Term Definition
Connected
Routes
Total number of connected routes in the routing table.
Static Routes Total number of static routes in the routing table.
OSPF Routes Total number of routes installed by OSPFv3 protocol.
Reject Routes Total number of reject routes installed by all protocols.
Number of
Prefixes
Summarizes the number of routes with prefixes of different lengths.
Total Routes The total number of routes in the routing table.