NETGEAR GSM7228PS - Show Ipv6 Ospf Interface Brief

Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-62
v1.0, July 2010
The following information only displays if OSPF is initialized on the interface:
show ipv6 ospf interface brief
This command displays brief information for the IFO object or virtual interface tables.
Retransmit
Interval
The frequency, in seconds, at which the interface sends LSA.
Hello Interval The frequency, in seconds, at which the interface sends Hello packets.
Dead Interval The amount of time, in seconds, the interface waits before assuming a neighbor is down.
LSA Ack
Interval
The amount of time, in seconds, the interface waits before sending an LSA
acknowledgement after receiving an LSA.
Iftransit Delay
Interval
The number of seconds the interface adds to the age of LSA packets before
transmission.
Authentication
Type
The type of authentication the interface performs on LSAs it receives.
Metric Cost The priority of the path. Low costs have a higher priority than high costs.
Passive Status Shows whether the interface is passive or not.
OSPF MTU-
ignore
Shows whether to ignore MTU mismatches in database descriptor packets sent from
neighboring routers.
Term Definition
OSPF Interface
Type
Broadcast LANs, such as Ethernet and IEEE 802.5, take the value broadcast. The OSPF
Interface Type will be 'broadcast'.
State The OSPF Interface States are: down, loopback, waiting, point-to-point, designated
router, and backup designated router.
Designated
Router
The router ID representing the designated router.
Backup
Designated
Router
The router ID representing the backup designated router.
Number of Link
Events
The number of link events.
Metric Cost The cost of the OSPF interface.
Term Definition