Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-40
v1.0, July 2010
area nssa no-summary (OSPFv3)
This command configures the NSSA so that summary LSAs are not advertised into the NSSA.
no area nssa no-summary (OSPFv3)
This command disables nssa from the summary LSAs.
area nssa translator-role (OSPFv3)
This command configures the translator role of the NSSA. A value of always causes the router to
assume the role of the translator the instant it becomes a border router and a value of candidate
causes the router to participate in the translator election process when it attains border router
status.
no area nssa translator-role (OSPFv3)
This command disables the nssa translator role from the specified area id.
area nssa translator-stab-intv (OSPFv3)
This command configures the translator <stabilityinterval> of the NSSA. The
<stabilityinterval> is the period of time that an elected translator continues to perform its
duties after it determines that its translator status has been deposed by another router.
Format area <areaid> nssa no-summary
Mode Router OSPFv3 Config
Format no area <areaid> nssa no-summary
Mode Router OSPF Config
Format area <areaid> nssa translator-role {always | candidate}
Mode Router OSPFv3 Config
Format no area <areaid> nssa translator-role {always | candidate}
Mode Router OSPF Config
To Next Page
Loading...
