Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-77
v1.0, July 2010
show ip ospf neighbor
This command displays information about OSPF neighbors. If you do not specify a neighbor IP
address, the output displays summary information in a table. If you specify an interface or tunnel,
only the information for that interface or tunnel displays. The <ip-address> is the IP address
of the neighbor, and when you specify this, detailed information about the neighbor displays. The
information below only displays if OSPF is enabled and the interface has a neighbor.
If you do not specify an IP address, a table with the following columns displays for all neighbors
or the neighbor associated with the interface that you specify:
LS Request 1 1
LS Update 141 42
LS Acknowledgment 40 135
Format show ip ospf neighbor [interface <unit/slot/port>] [<ip-address>]
Modes • Privileged EXEC
• User EXEC
Term Definition
Router ID The 4-digit dotted-decimal number of the neighbor router.
Priority The OSPF priority for the specified interface. The priority of an interface is a priority
integer from 0 to 255. A value of '0' indicates that the router is not eligible to become the
designated router on this network.
IP Address The IP address of the neighbor.
Neighbor
Interface
The interface of the local router in unit/slot/port format.
Packet Type Sent Received
To Next Page
Loading...
