NETGEAR GSM7228PS - Show Ip Mcast Mroute; Show Ip Mcast Mroute Group

Managed Switch CLI Manual, Release 8.0.3
IP Multicast Commands 5-5
v1.0, July 2010
show ip mcast mroute
This command displays a summary or all the details of the multicast table.
If you use the detail parameter, the command displays the following fields:
If you use the summary parameter, the command displays the following fields:
show ip mcast mroute group
This command displays the multicast configuration settings such as flags, timer settings, incoming
and outgoing interfaces, RPF neighboring routers, and expiration times of all the entries in the
multicast mroute table containing the given <groupipaddr>.
Format show ip mcast mroute {detail | summary}
Modes • Privileged EXEC
• User EXEC
Term Definition
Source IP The IP address of the multicast data source.
Group IP The IP address of the destination of the multicast packet.
Expiry Time The time of expiry of this entry in seconds.
Up Time The time elapsed since the entry was created in seconds.
RPF Neighbor The IP address of the RPF neighbor.
Flags The flags associated with this entry.
Term Definition
Source IP The IP address of the multicast data source.
Group IP The IP address of the destination of the multicast packet.
Protocol The multicast routing protocol by which the entry was created.
Incoming
Interface
The interface on which the packet for the source/group
arrives.
Outgoing
Interface List
The list of outgoing interfaces on which the packet
is forwarded.
Format show ip mcast mroute group <groupipaddr> {detail |summary}
Modes • Privileged EXEC
• User EXEC