Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-46
v1.0, July 2010
no snmp-server enable traps multiusers
This command disables Multiple User traps.
snmp-server enable traps stpmode
This command enables the sending of new root traps and topology change notification traps.
no snmp-server enable traps stpmode
This command disables the sending of new root traps and topology change notification traps.
snmptrap
This command adds an SNMP trap receiver. The maximum length of <name> is 16 case-sensitive
alphanumeric characters. The <snmpversion> is the version of SNMP. The version parameter
options are snmpv1 or snmpv2. The SNMP trap address can be set using both an IPv4 address
format as well as an IPv6 global address format.
The following shows an example of the CLI command.
(Netgear Switch)# snmptrap mytrap ip6addr 3099::2
Format no snmp-server enable traps multiusers
Mode Global Config
Default enabled
Format snmp-server enable traps stpmode
Mode Global Config
Format no snmp-server enable traps stpmode
Mode Global Config
To Next Page
Loading...
