Managed Switch CLI Manual, Release 8.0.3
IP Multicast Commands 5-29
v1.0, July 2010
ip igmp query-max-response-time
This command configures the maximum response time interval for the specified interface, which
is the maximum query response time advertised in IGMPv2 queries on this interface.The time
interval is specified in tenths of a second. The range for <maxresptime> is 0 to 255 tenths of a
second.
no ip igmp query-max-response-time
This command resets the maximum response time interval for the specified interface, which is the
maximum query response time advertised in IGMPv2 queries on this interface to the default value.
The maximum response time interval is reset to the default time.
ip igmp robustness
This command configures the robustness that allows tuning of the interface. The robustness is the
tuning for the expected packet loss on a subnet. If a subnet is expected to have a lot of loss, the
Robustness variable may be increased for the interface. The range for <robustness> is 1 to
255.
no ip igmp robustness
This command sets the robustness value to default.
Default 100
Format ip igmp query-max-response-time <seconds>
Mode Interface Config
Format no ip igmp query-max-response-time
Mode Interface Config
Default 2
Format ip igmp robustness <robustness>
Mode Interface Config
Format no ip igmp robustness
Mode Interface Config
To Next Page
Loading...
