Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-84
v1.0, July 2010
storm-control multicast (Global Config)
This command enables multicast storm recovery mode for all interfaces. If the mode is enabled,
multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on an interface
increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate of
multicast traffic will be limited to the configured threshold.
no storm-control multicast
This command disables multicast storm recovery mode for all interfaces.
storm-control multicast level (Global Config)
This command configures the multicast storm recovery threshold for all interfaces as a percentage
of link speed and enables multicast storm recovery mode. If the mode is enabled, multicast storm
recovery is active, and if the rate of L2 multicast traffic ingressing on an interface increases
beyond the configured threshold, the traffic will be dropped. Therefore, the rate of multicast traffic
will be limited to the configured threshold.
Format no storm-control multicast rate
Mode Interface Config
Default disabled
Format storm-control multicast
Mode Global Config
Format no storm-control multicast
Mode Global Config
Default 5
Format storm-control multicast level
<0-100>
Mode Global Config
To Next Page
Loading...
