Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-97
v1.0, July 2010
lacp actor port priority
Use this command to configure the priority value assigned to the Aggregation Port. The valid
range for <priority> is 0 to 255.
no lacp actor port priority
Use this command to configure the default priority value assigned to the Aggregation Port.
lacp actor system priority
Use this command to configure the priority value associated with the LACP Actor’s SystemID.
The range for <priority> is 0 to 65535.
Default 0x80
Format lacp actor port priority <priority>
Mode Interface Config
Note: This command is only applicable to physical interfaces.
Format no lacp actor port priority
Mode Interface Config
Default 32768
Format lacp actor system priority <priority>
Mode Interface Config
Note: This command is only applicable to physical interfaces.
To Next Page
Loading...
Need help?
General
